Your water heater is one of the used and costly appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving from the home heating and costs.
Regular flushing of the water heater is among the single most important step you can take to prolong its service life and to save energy. A duration of time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regarding the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your hot water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is vital in today’s weather. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, on the internet should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on a water inlet line going into your water heater. You can then connect a hose to the drain valve located at the bottom of the heater. Open the drain and allow it to play until all from the water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the hot water heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until the flows out quickly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so it is less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and merchandise to suit your needs.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610